Wojtek Wiesławski
Tutorials

How to Start a Mix: A VU Meter Starting Point

A fast static balance from kick to vocals on a VU meter — before you touch EQ or compression.

Chapters

You’ve loaded your tracks into the session ⁠—⁠ now what? In this tutorial Wojtek Wieslawski shows the starting point he uses on every mix: a quick level balance on a VU meter that gets the mix dynamic, not too quiet, not too loud and not clipping the master bus within minutes.

Why a VU meter instead of a peak meter

The VU meter comes from analog consoles. It shows averaged level rather than instantaneous peaks, so it reflects perceived balance much better. Keep in mind that 0 VU usually equals around -18 dBFS in your DAW (the calibration can be changed in the plugin settings). Wojtek puts a VU meter on the master bus and builds the balance from there.

The balance, step by step

  1. Kick at about -7 VU. Single hits will read a little lower, double kick around -7. If the song is mostly double kick, set the double kick to -7.
  2. Bass against the kick. A simple trick: with the kick at -7, bring the bass up until kick and bass together read about -3 VU.
  3. Snare against the kick. Depending on the genre the snare sits level with the kick or slightly below ⁠—⁠ this is where your ears take over.
  4. Cymbals to taste. Kick and snare lead; cymbals support them.
  5. Vocals up front. Level with kick and snare, or slightly louder.
  6. Everything else (guitars, acoustics, keys): push the fader up from the bottom until it feels right. If you overshoot, pull it down and bring it up again.

Loudness and references

Finally, Wojtek adds a fairly transparent limiter to the master ⁠—⁠ one that doesn’t dull the transients ⁠—⁠ and raises the mix to the level its references play at ⁠—⁠ which depends on the genre and on the references themselves. Only at matched loudness is a comparison with a reference track fair.

This rough mix takes a few minutes and gives you a solid foundation before you reach for EQ and compression.

FAQ

Where should the kick sit on a VU meter at the start of a mix?
Around -7 VU is a good starting point, with kick and bass together around -3 VU. Treat it as a starting point, not a rule.

Does this approach work for every genre?
As a starting point, yes. You then adjust snare, vocal and guitar levels by ear depending on the style and your references.

Why put a limiter on the master so early?
So you can compare your mix with references at similar loudness. Louder always sounds better, so without matching levels it’s easy to make the wrong calls.

Tools in this episode

  • Reaper (DAW)
  • TBProAudio mvMeter2 (VU meter)
  • IK Multimedia Stealth Limiter
  • IK Multimedia TRackS Metering

Work on your music

Explore mixing services