Mid-Side Processing: A Simple Fix for Problems in a Finished Mix
Using mid/side EQ and de-essing to fix cymbals, snare, vocals and bass in a bounced mix.
Chapters
Your mix is finished, you can’t or don’t want to go back to the multitracks, yet there’s still work to do: too much sibilance on the vocal, no air in the cymbals, a bit too much low end in the bass? In this episode Wojtek Wieslawski shows how to fix this in a finished mix with mid-side processing.
What mid-side is
A stereo signal has a left and right channel. Mid is everything identical in both channels; side is the difference between them. Soloing the mid you hear vocals, kick, snare, bass and some guitars — the cymbals are barely there. In the side, guitars dominate, followed by vocal effects and cymbals. Because instruments spread differently, you can process them separately.
1. Air in the cymbals
In your EQ (Pro-Q 3 here) switch a band to side and find the cymbal frequencies. A boost brightens the cymbals while the vocal stays put.
2. Snare body
The snare sits in the mid. Switch the band to mid and find where the snare has the most body. The snare changes, and a little of the bass too, since it’s also in the mid — but the guitars aren’t affected.
3. Vocal sibilance
Modern plugins — EQs, compressors and de-essers — have offered mid/side modes for a long time. A de-esser (DMG Essence here) set to the mid only tames vocal sibilance, leaving the cymbals in the side untouched. Kick and snare attack live in similar frequencies, so check by ear.
4. Bass balance
Want to take some body out of the bass without touching the guitars? Work in the mid and reduce the chosen band. The bass steps back while the guitars in the side stay unchanged.
FAQ
Does mid-side work on a finished stereo mix?
Yes — that’s its biggest advantage. You can fix elements that sit differently in mid and side without the multitracks.
What usually sits in the mid and what in the side?
Typically vocals, kick, snare and bass in the mid; wide guitars, cymbals and effects in the side. It depends on the mix, so always listen to both channels separately.
Tools in this episode
- Cubase (DAW)
- FabFilter Pro-Q 3
- DMG Audio Essence
Work on your music
Music courtesy of: Rusted Teeth – Burn The Dark.