Wojtek Wiesławski
Tutorials

How to Set a Compressor in a Mix: The 5-Step Method

A simple, repeatable routine for setting any compressor — demonstrated on acoustic guitar.

Chapters

When do you need a compressor, how should you set it, and should you do it in solo or in the mix? In this episode Wojtek Wieslawski shows a five-step method you can use on any project ⁠—⁠ vocals, guitar or bass. The example is an acoustic guitar in a song by Dilluvium, compressed with a Distressor. If compression is new to you, start with the earlier episode on how a compressor works.

Step 1: listen in the context of the mix

Focus on the instrument and ask what it’s missing. The acoustic is uneven ⁠—⁠ sometimes hit too hard, sometimes too soft. Mostly the pick scrape comes through, while the sustain hides behind bass and drums. That’s a job for a compressor: even out the strums and give them a defined attack and sustain.

Step 2: deliberately over-compress

In solo, set a ratio around 10:1 and a threshold (or input) that gives at least 10 dB of reduction. Leave attack and release in the middle. With compression this heavy it’s much easier to hear what attack and release do. It sounds bad ⁠—⁠ and it’s supposed to.

Step 3: attack and release

At the fastest attack the pick transient can’t get through ⁠—⁠ the acoustic is squashed. At the slowest the compressor doesn’t catch the transient at all. You’re looking for the point in between where the attack sounds natural but controlled. Then release: too slow chokes the instrument and pumps out of time; too fast creates a jerk right after the attack. The sweet spot is no pumping and no notes jumping out.

Step 4: match the level

Set make-up gain so the level is about the same with the compressor on and bypassed. Otherwise you’re judging loudness, not character.

Step 5: ease off in the context of the band

Take it out of solo and ⁠—⁠ without touching attack or release ⁠—⁠ lower the ratio to a safer 4⁠–⁠6:1 and raise the threshold for around 4⁠–⁠6 dB of reduction. Always match levels when comparing. If the mix calls for a small tweak to attack or release, go ahead.

Ratio in practice

On individual tracks usually 4⁠–⁠6:1, sometimes 8:1; very gentle is 3:1. 10:1 works great for parallel compression or for really crushing a signal, and 20:1 is effectively a limiter.

FAQ

Should I set a compressor in solo or in the mix?
Diagnose and finalise in the mix. Solo only helps during the over-compressed stage when you’re finding attack and release.

What ratio should I start with on a single track?
Usually 4⁠–⁠6:1 with around 4⁠–⁠6 dB of gain reduction.

Tools in this episode

  • Universal Audio Distressor

Work on your music

Explore mixing services

View the course (in Polish)

Music courtesy of: Dilluvium ⁠–⁠ Alive.