Wojtek Wiesławski
Tutorials

90% of Mixes Sound Unclear Because of This Mistake: Subtractive EQ

Mixing stage zero: cutting muddy frequencies track by track before you boost anything.

Chapters

Before you boost anything with an EQ or reach for the first compressor ⁠—⁠ stop. Most beginners, and sometimes even advanced engineers, skip one stage and then fight muddy mixes for ages. In this episode Wojtek Wieslawski demonstrates the “stage zero” of a mix on SkyLorn’s unprocessed tracks.

Why boosting highs doesn’t work

When a mix is muddy, a common reaction is to boost the top end. It creates an impression of clarity, but the muddy frequencies are still there ⁠—⁠ just masked. The problem needs fixing at the source.

Subtractive EQ: take away, don’t add

Stage zero comes right after a quick rough balance, before proper EQ and compression. It means cleaning the tracks of “junk” frequencies that eat space and headroom while adding nothing. You’re not looking for character yet ⁠—⁠ you’re only removing what’s in the way, plus a high-pass or low-pass where it makes sense. Use headphones or monitors where you can clearly hear what you’re cutting.

Track by track

  • Kick: the biggest cut around 210 Hz, another near 400 Hz, a little off the very top and a cut below about 25 Hz. The tone stays the same, but the kick is far clearer ⁠—⁠ like wiping a window clean.
  • Snare: cuts around 380 and 580 Hz and in the 400⁠–⁠750 Hz range (the snare’s mud), a little low end below 100 Hz and a touch off the very top. It becomes tight and in-your-face.
  • Toms: a big cut around 300 Hz, some top and lows below about 30 Hz. They cut through better.
  • Overheads: mainly a strong low cut ⁠—⁠ in the cymbals you want cymbals, not kick and snare ⁠—⁠ plus cuts around 400 Hz and about 3.5 kHz where they were harsh.
  • Bass: cuts around 200 and 330 Hz and removing the harsh very top from the drive.
  • Rhythm and lead guitars: lows around 90⁠–⁠120 Hz, low mids around 360 Hz, a harsh band around 3.3 kHz and the top above about 10 kHz.
  • Keys: a clear cut around 300 Hz and lows below about 80 Hz ⁠—⁠ making room for the guitars.
  • Vocals: mids around 380 Hz, a resonance around 720 Hz, lows below about 80 Hz (Wojtek cuts them at the mic already) and two cuts on the hissy top.

After these corrections, rebalance too.

The golden rule: start with the mids

The overwhelming majority of cuts fell in roughly 150⁠–⁠700 Hz. That’s the low-mid range where guitars, bass, the lower body of vocals, keys and snare all pile up ⁠—⁠ and that’s where the mud lives. Start in the middle; once it’s clean the instrument opens up completely, and only then decide whether you need a low cut or high cut. For where to clean each instrument, see also the instrument frequency chart.

FAQ

What is subtractive EQ?
EQ by subtraction: you cut muddy, unnecessary frequencies before boosting anything.

Where does mud usually sit in a mix?
In the low mids, roughly 150 to 700 Hz.

Work on your music

Explore mixing services

View the course (in Polish)

Music courtesy of: SkyLorn.