Wojtek Wiesławski
Tutorials

The EQ That Ruins Your Vocals in the Mix — and How to Fix It

Why the standard "low cut and top boost" spoils vocals, and how to do it dynamically instead.

Chapters

Struggling to make your vocal sit in the mix? According to Wojtek Wieslawski, one of the most common mistakes is badly set EQ. In this short tutorial he shows a typical setting he sees all the time, and his own way to get a vocal that’s clear but still warm and full.

“Cut the lows, boost the highs”

The standard advice is: cut the lows, add top, scoop something out of the mids. The vocal does get clearer ⁠—⁠ but clarity isn’t everything; tone matters too. The cardinal mistake is cutting the low end hard until whatever you dislike disappears. Singers don’t stay low all the time, and on higher notes a vocal without low end sounds very hollow. On top of that the boosted highs start to hiss, so you have to add a de-esser.

How Wojtek does it

  1. Mids first, then highs. Before boosting anything, check whether something in the low mids is getting in the way.
  2. A gentle low cut. Just enough for the vocal to sit better under compression ⁠—⁠ more about removing a resonance at the very bottom than cutting everything up to about 180 Hz as in the first example.
  3. Dynamic EQ instead of static. Find the annoying frequency in the mids and cut it dynamically. When the singer goes lower and that band builds up, the EQ cuts more ⁠—⁠ it responds to what’s coming in.
  4. A de-esser at any frequency. If the vocal gets muddy only on certain syllables, a de-esser set to that band is ideal.

In the comparison, the standard EQ did more harm than good: it flattened the low end and added ugly top.

Don’t use presets blindly

A male or female vocal, a different microphone, a different room ⁠—⁠ it will always sound different. Find settings for the track in front of you instead of copying ones that once worked for you or someone else.

FAQ

How much low end should I cut from a vocal?
Less than you think. A heavy low cut makes higher passages sound hollow ⁠—⁠ removing a specific resonance is better.

Dynamic or static EQ on vocals?
Dynamic for bands that only cause trouble on certain notes ⁠—⁠ it cuts exactly when needed.

Tools in this episode

  • Cubase (DAW)
  • FabFilter Pro-Q 3
  • DMG Audio Essence

Work on your music

Explore mixing services

View the course (in Polish)